Hi Euan, DVEVM demo works out of the box because there's a small script "dvevmdemo" that runs at boot-up. And the script is located at /etc/init.d/ dir in your DVEVM file system. The app also is located somewhere on the DVEVM file system.
With the above information, you should be able to figure out how to load and run you app automatically. Thanks, Somnath -----Original Message----- From: Cochrane, Euan [mailto:[EMAIL PROTECTED] Sent: Thursday, December 13, 2007 3:49 PM To: Mukherjee, Somnath; Davinci-Linux-Open-Source (E-mail) Subject: RE: boot and load app without host machine Thanks, I followed that app note and I now have my uImage on the flash and my DVEVM boots without the Ethernet connection to the host. now I want to have the board load my app once it finishes booting i.e. so I don't have to login as root and load the app manually over the serial connection. I'm sure this can be done as this is how the board behaves out of the box with the TI demo apps (encode, decode, encodedecode etc in the menu interface). how do I set this up for my app? Thanks Euan -----Original Message----- From: Mukherjee, Somnath [mailto:[EMAIL PROTECTED] Sent: 13 December 2007 09:30 To: Cochrane, Euan; Davinci-Linux-Open-Source (E-mail) Subject: RE: boot and load app without host machine Why don't you burn the uImage on the flash itself? Did you see the attached doc before? Thanks, Somnath -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Cochrane, Euan Sent: Thursday, December 13, 2007 2:48 PM To: Davinci-Linux-Open-Source (E-mail) Subject: boot and load app without host machine Hey, at the moment I boot my DVEVM via TFTP and launch my app from the command line using minicom. I now need to do some testing with a machine in another part of the site and I don't want to have to bring my host machine with me. What I want to do is have the DVEVM boot using my boot image that I created and then load my app once the boot has completed so that I don't need to have the DVEVM connected to my host. How can I do this? Currently the uImage I want to use is on the host PC hard drive in /tftpboot and my app I want to run is on the DVEVM hard drive in /opt/dvevm. Thanks, Euan _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
