Hi,
I am working on DM355 davinci board and facing problem of Bad Block.
When I boot in NAND Mode, Bad Block errors come from starting address
(0x00000000).
It is working in UART Mode.
I wrote one program to erase and check bad block. When I erased and read the
blocks, there is no bad block error, while during nand mode I faced same
problem.
What is the solution for same?
Thanks & Regards
Amod Kaveeshwar
(Embedded Engineer)
Einfochips Ltd | National Plaza|Ahmedabad
(M) : +91-9979097544
--
eInfochips Business Disclaimer:
This message may contain confidential, proprietary or legally Privileged
information. In case you are not the original intended Recipient of the
message, you must not, directly or indirectly, use, Disclose,distribute,
print, or copy any part of this message and you are requested to delete
it and inform the sender. Any views expressed in this message are those
of the individual sender unless otherwise stated.Nothing contained in
this message shall be construed as an offer or acceptance of any offer
by eInfochips Limited and/or eInfochips Inc(“eInfochips”) unless sent
with that express intent and with due authority of eInfochips.EInfochips
has taken enough precautions to prevent the spread of viruses. However
the company accepts no liability for any damage caused by any virus
transmitted by this email.
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
