Hi, it could be another simple question, but i'm quite confused. I'm giving this on a command line: # cat /proc/gio/gio6 1 # echo 0 > /proc/gio/gio6 # cat /proc/gio/gio6 0
but i'm not getting any result on a tester connected to the evm board. ( gpio6 should be connected on the fifth pin of "DC5 - TH8200 DaughterCardInterface" connector ) Should I activate something before use the dc5 connector? Is there something that i didn't understand? Thanks a lot, bye! -- Andrea Gasparini ---- ImaVis S.r.l. ---- web: www.imavis.com _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
