You may check the position of Switch S3 4. It shold be set to be "on".
Best regards! --------------------- Cheng Yang 杨成 Digital Signal Processing and Transmission Lab E.E. Department, Fudan University Shanghai, P.R. China Lab: +86 (0) 21 65643633 Mobile: +86 13818155051 Email: [EMAIL PROTECTED] ----- Original Message ----- From: [EMAIL PROTECTED] To: [email protected] Sent: Tuesday, March 25, 2008 5:27 PM Subject: Can't run demos with DVEVM1.2 Hi all, Has anyone encountered a problem trying to run the encode, decode, encodedecode stuff with DVEVM1.2? I was using DVEVM1.0 and uboot 1.1.3 with my custom board and everything was working great. However, when i upgraded to DVEVM1.2, the demos no longer work. I haven't changed the u-boot yet. Heres what happens: 1. I run loadmodules.sh 2. run demo code i.e. ./encodedecode 3. Then the output goes something like: encodedecode demo started (pause for about 10s) TraceUtil -> Failed to open codec engine encodedecode Does this have something to do with u-boot? Everything was working fine with DVEVM1.0 and uboot 1.1.3 so that's my only guess. -Andrew ------------------------------------------------------------------------------ Planning your summer road trip? Check out AOL Travel Guides. ------------------------------------------------------------------------------ _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
