Hi all,

I am trying to boot the board via TFTP using Board's NAND Flash File System,
as explained at the Getting Started Guide, at section A.3.2 page A-9.

I am not able to perform the tftp transfer with two different configurations

This is strange since it was supposed that it tries to boot via tftp. Here
are my environment variables for two configurations:

   1. Direct connection between the host and the EVM board using a cross
cable:

      bootdelay=3
      baudrate=115200
      stdin=serial
      stdout=serial
      stderr=serial
      videostd=pal
      bootcmd=bootm
      bootargs=mem=116M console=ttyS0,115200n8 root=/dev/mtdblock3 rw
rootfstype=yaffs2 ip=192.168.1.10
      bootfile=uImage-dm355
      serverip=192.168.1.53

      Nonetheless after performing all steps described, when I boot the
result is the following:

     ## Booting image at 80700000

     Bad Magic Number

   2. Exactly as explained on the manual at my company's LAN

      bootdelay=3
      baudrate=115200
      stdin=serial
      stdout=serial
      stderr=serial
      videostd=pal
      bootargs=mem=116M console=ttyS0,115200n8 root=/dev/mtdblock3 rw
rootfstype=yaffs2 ip=dhcp
      bootcmd=dhcp;bootm
      serverip=10.112.40.14

      bootfile=uImage-dm355

   At this case here are the results

      DM355 EVM # boot

      BOOTP broadcast 1
      *** Unhandled DHCP Option in OFFER/ACK: 43
      *** Unhandled DHCP Option in OFFER/ACK: 43
      DHCP client bound to address 10.112.40.239
      TFTP from server 10.112.15.19; our IP address is 10.112.40.239;
sending through gateway 10.112.40.254
      Filename 'uImage-dm355'.
      Load address: 0x80700000
      Loading: T T T T T T T T T T T T T T T T T T T T
      Retry count exceeded; starting again
      BOOTP broadcast 1
      *** Unhandled DHCP Option in OFFER/ACK: 43
      *** Unhandled DHCP Option in OFFER/ACK: 43
      DHCP client bound to address 10.112.40.239
      TFTP from server 10.112.15.19; our IP address is 10.112.40.239;
sending through gateway 10.112.40.254
      Filename 'uImage-dm355'.
      Load address: 0x80700000
      Loading: T T
      Abort

      DM355 EVM #

      In this case, it seems that the board is trying to access the tftp
server (as opposed with the previous case, where the board desn't try). The
problem in this case is       that he is trying to connect to a tftp server
different from that configured!!!


Does anybody had this problem?

Thanks in advance,

A.SIlva
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source

Reply via email to