Hi ,
I am working on the davinci .now I encouter a difficult . By reading the
dm6446 datum, I have known that the boot mode of dsp core . I think set DSP_BT
pin to '1' state .using the ccs configure for davinci to emulate it .but I get
the following errrors :
Error connecting to the target:
Error 0x80000260/-1137
Fatal Error during: Execution, Initialization, OCS,
It appears that the target is being held in reset. This may be
due to Wait-In-Reset (WIR) configuration set by the EMU0=0
and EMU1=1 pin settings. If this is the case, DISCONNECT
all CONNECTED devices including icepick and then select
RETRY to clear the WIR configuration.
If this is a multi-core system, the master CPU may not be
releasing the DSP/MCU from reset. Please check your
configuration in CC_setup and/or your GEL file to ensure that
nothing is blocking the DSP/MCU from being released from reset
Board Name: DM6446 XDS560 Emulator
Cpu Name: C6400PLUS_0
Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.
Who can give me some advise ? Thanks a lot!
我遥望远处的天空，寻找你的影子。
---------------------------------
雅虎邮箱，您的终生邮箱！_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
