Gabriele,
Yes, the Blackhawk BH-USB-2 should support 1.8V I/O. On the 14-pin
JTAG header on your target board, what is pin 5 connected to? This is the
Power Detect pin that is used by the BH-USB-2 to understand the I/O voltage
level.
Brandon Azbell
________________________________________
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Gabriele Filosofi
Sent: Thursday, June 19, 2008 1:47 AM
To: [email protected]
Subject: Does Blackhawk BH-USB-2 emulator support 1.8V targets?
Hi
Does anyone knows whether does Blackhawk BH-USB-2 emulator support 1.8V targets?
I would like to use this emulator with our DM6441-based custom board (silicon
revision 1.3).
As reported in the datasheet, this emulator pod supports 1.0 to 5.0 volt.
This concern arises from the fact that I see an error message "CANNOT DETECT
TARGET POWER" when I invoke the emulation reset from CCS_3.2 IDE.
Thanks and regards
Gabriele Filosofi
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
Ing. Gabriele Filosofi
[EMAIL PROTECTED]
COSMED srl, R&D Department
P.O. Box 3
Via dei Piani di Monte Savello, 37
00040 - Pavona di Albano, Rome - ITALY
Voice: +39-06 931 5492, Fax: +39-06 931 4580
http://www.cosmed.it
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
