Hi, I am wondering about the dependence of MSP430 processor on DM355 EVM board. Since MSP430 processor is communicating with DM355 via I2C protocol, When I erased MSP430 firmware from its flash, then i countered a case;
Buttons are not recognized by DM355 SD/MMC is not recognized by the processor, and so on... Without msp430 controller how can i acess SD/MMC and any other devices? does this require some changes device driver codes? OR is there any solution? After reloading the firmware all stuff works again. regards...
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
