Hi,
LPJ can't damage your board AFAIK, where did you find such reference?
It's only a calibration value that is calculated at boot time but it
won't hurt your board. Be aware that this value will be different
depending on the clocking of your system.
Regards,
Diego.
On Sep 25, 2008, at 11:32 PM, <[EMAIL PROTECTED]> <[EMAIL PROTECTED]
> wrote:
Hi all,
I want to reduce bootup time on DM355 based board.
One of the technique is to use correct LPJ value in the bootargs.
I have found how to get LPJ value on our board.
But there is one caution that if we use incorrect LPJ value it might
damage the board.
So I want to know what should be allowable range of LPJ value which
will not damage the board and helps in reducing bootup time.
Like suppose LPJ value for my board is 538624, but lets say I am
using (538624 +/- 50) than it won't affect my board and if I am using
(538624 +/- 100) or more that it will damage my board.
I want to know acceptable LPJ value range on DM355 based board.
Thanks in advance.
Regards,
Jitendra
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
