You'll need either a JTAG debugger or a program to load the NAND via the
serial port. I've used a BDI2000 on a DM355 board that I'm working on.
The wiki has some information on this:
http://wiki.davincidsp.com/index.php?title=RBL_UBL_and_host_program
I know TI was working on a serial loader for the DM355, but I'm not sure
of the current state of that work.
Jeff
Panchy Rivas wrote:
When we first populate a custom DM355 PCB how do we get Uboot, kernel,
software
on it?
Thanks
Panchy Rivas
--
Jeff Cooper // senior embedded software engineer
LOGIC // engineering design services
411 Washington Ave. N. Suite 400
Minneapolis, MN 55401
T // 612.436.5176
F // 612.672.9489
[EMAIL PROTECTED]
www.logicpd.com
/ / / / / / / / / / / / / / / / / / / / / / / / / / / /
This message (including any attachments) contains confidential
information intended for a specific individual and purpose, and
is protected by law. If you are not the intended recipient, you
should delete this message and are hereby notified that any
disclosure, copying, distribution, or other use of this message,
or the taking of any action based on it, is strictly prohibited.
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
