Hi all,
I am trying to bring-up our custom board (DM6446) with NOR flash.
We have maintained the DDR and NOR part numbers same as DVEVM
I am using DV_Flasher tool to flash u-boot into NOR, which is successful.
Now if I change the boot mode from UART back to NOR, I am getting following
message
(from UBL)
TI UBL Version: 1.143, Flash type: NOR
Booting PSP Boot Loader
PSPBootMode = NOR
Starting NOR Copy...
NOR Initialization:
Command Set: Intel
Manufacturer: INTEL
Size (in bytes): 0x01000000
NOR Boot success.
DONE
After this I assume, it should start UBOOT from DDR, but it stuck there itself
What could be the reason,/ is it like not getting the APP entry point and
waiting thr or DDR is not working properly?
Appreciate your quick help!
Thanks and Regards,
Nitin Joshi
________________________________
This message (including attachment if any) is confidential and may be
privileged. If you have received this message by mistake please notify the
sender by return e-mail and delete this message from your system. Any
unauthorized use or dissemination of this message in whole or in part is
strictly prohibited. E-mail may contain viruses. Before opening attachments
please check them for viruses and defects. While MindTree Limited (MindTree)
has put in place checks to minimize the risks, MindTree will not be responsible
for any viruses or defects or any forwarded attachments emanating either from
within MindTree or outside.
Please note that e-mails are susceptible to change and MindTree shall not be
liable for any improper, untimely or incomplete transmission.
MindTree reserves the right to monitor and review the content of all messages
sent to or from MindTree e-mail address. Messages sent to or from this e-mail
address may be stored on the MindTree e-mail system or else where.
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
