Hi， Everyone。I have some problems about my platform of davinci dm6446, which is developed by my professor's group. The problem is: When I run the encodedecode demo on my platform, after a few seconds, the DSP CPU load is 99%，and then the system will halt for ever. Can anyone tell me the possible problems about my platform: 1. our platform has no TVP5146, and the video source is generated by FPGA, and its format is BT656. When I use the command： ./encodedecode -p (that means no encode or decode,but only passthrough) it will have no problems for a long while. 2. Could the problem will be generated by the DDR2 SDRAM? Such as DDR2 pins have no same length of the PCB lines？ 3. Could anyone give me some ways to solve the problems? and the accessory is my platform and the error, now it shows the dsp cpu load is 99%, and the system is halted.but the arm (linux)is not halted.
-- Best Regards! zhangshaofeng [EMAIL PROTECTED] [EMAIL PROTECTED] @Xi'an JiaoTong University
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
