Hi Everyone,
After some frustration using DVFlasher and MONO to program my
DaVinci board, I have decided to write a pure UNIX/Linux serial
loader/flasher application called dvnixload. Here is the project web
page:
http://www.hugovil.com/en/dvnixload/
I have tested it successfully to program the UBL[1] and
U-Boot in the NAND flash on my DM6446-based SFFSDR board. Tests were
done with an old-fashioned serial port as well as a USB to
serial converter with success.
It is very simple to use as you don't have to pass command
line arguments to specify the UBL or application load address: this
information is automatically extracted from the ELF headers (input
files are in ELF format).
If some people find it useful, maybe we could post a link about it on
the TI DaVinci wiki.
Comments/suggestions/patches are welcomed.
Hugo Villeneuve.
[1] Use the UBL from this location:
http://trac.geekisp.com/opensdr/browser/HW_tools/sff_sdr/serial_loader/trunk/DVFlasher/ubl
See the manual for the explanation
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
