Hello All,
I am facing an issue in the I2C communication in the Davinci Dm355
processor. We have taken the Montavista TI Davinci code as the base. In
that, we have MSP430 device. But, in our case, we have made a custom
based board that don't have MSP430 device.
Processor will always acts as a master and the other devices connected
to the processor will work as the slave. As per our board design, we
need the I2C data line to be high always for successful communication.
But, the Montavista TI Davinci Linux code reset this line to zero as
till the kernel gets booted the I2C data line is high. Hence we don't
know, what makes the I2C data line to low!
Does anyone face the similar issue?
Please reply.
Thanks a lot in advance.
Regards,
Prabhaharan.R
DISCLAIMER:
-----------------------------------------------------------------------------------------------------------------------
The contents of this e-mail and any attachment(s) are confidential and intended
for the named recipient(s) only.
It shall not attach any liability on the originator or HCL or its affiliates.
Any views or opinions presented in
this email are solely those of the author and may not necessarily reflect the
opinions of HCL or its affiliates.
Any form of reproduction, dissemination, copying, disclosure, modification,
distribution and / or publication of
this message without the prior written consent of the author of this e-mail is
strictly prohibited. If you have
received this email in error please delete it and notify the sender
immediately. Before opening any mail and
attachments please check them for viruses and defect.
-----------------------------------------------------------------------------------------------------------------------
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
