Hello,
Has anyone successfully flashed with v1.10 of the dm646x serial
flasher?
I can't seem to get the serial host flash (sfh) utility to reflash my
dm6467 EVM. I can flash dm6446 and dm355 without any problems.
The utility finds the 'BOOTME', 'BEGIN' and 'BOOTUBL' commands, but
then just loops with the target sending the 'BOOTUBL' commands (see below)
The TechRef is a bit confusing about DIP switch settings, but for
NAND booting, SW3[4:1]=1110 and for UART boot I set SW3[4:1]=0001
Kevin
-----------------------------------------------------
TI Serial Flasher Host Program for DM646x
(C) 2008, Texas Instruments, Inc.
Ver. 1.10
-----------------------------------------------------
Platform is Windows.
Flashing NAND with ubl\ubl_DM646x_nand.bin and u-boot.bin.
Attempting to connect to device COM1...
Press any key to end this program at any time.
Waiting for the DM646x...
BOOTME commmand received. Returning ACK and header...
ACK command sent. Waiting for BEGIN command...
Target: BEGIN
BEGIN commmand received. Sending CRC table...
CRC table sent. Waiting for DONE...
DONE received. Sending the UBL...
DONE received. UBL was accepted.
UBL transmitted successfully.
Target: Chip initialization passed!
Target: TI SFT Version: 1.10
Target: Booting Catalog Boot Loader
Target: BootMode = Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
Target: Starting UART Boot...
Target: BOOTUBL
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
