From: canibek sağın [mailto:[email protected]] Sent: Tuesday, December 16, 2008 7:44 AM To: 'Woods, Scott' Subject: RE: Flashing Nand Flash I don't want to use comands on terminal, I want to load my file system to my board via jtag, Is it possible? I want to load ubl-uboot-and file system to nand flash via jtag. I want to speed up our production process . What is the fastest way for Flashing nand flash? Unfortunately there is no empty place on uarts on our dm355 uart0 is using for communicating with a mcu on our board , Uart1 is going to use for communicating for GPS kit, so I have to use Jtag for it. From: Woods, Scott [mailto:[email protected]] Sent: Tuesday, December 16, 2008 7:35 AM To: canibek sağın Subject: RE: Flashing Nand Flash Once you have ubl and u-boot on your board, you can use uboot to write the oterh things you need. Just use tftpboot from uboot to download your files into memory and do a nand clean + nand write. _____ From: davinci-linux-open-source-bounces+swoods=pelco....@linux.davincidsp.com [mailto:davinci-linux-open-source-bounces+swoods=pelco....@linux.davincidsp. com] On Behalf Of canibek sagin Sent: Tuesday, December 16, 2008 8:22 AM To: 'Phil Quiney' Cc: [email protected] Subject: Flashing Nand Flash Hi All, I have some empty nand flashes. I want to burn them and add my uImage,uboot,ubl, and File system. I googled and figure out that there is a way for serial port but on my board there is no rs 232. My board only have JTAG. I wonder that , I can write ubl and uboot to empty flashes via xds 510 and CCS 3.3 but what about filesystem? How may I add it to nand flash? On serial production It is very difficult to use serial port and some commands which is described on getting started guide for dm355. I have bought also peedi, for nand flash programming but it is not supporting dm355 I couldn't use it. I want to burn my new flashes with xds510, Is it possible? - ---------------------------------------------------------------------------- -- Confidentiality Notice: The information contained in this transmission is legally privileged and confidential, intended only for the use of the individual(s) or entities named above. This email and any files transmitted with it are the property of Pelco. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any review, disclosure, copying, distribution, retention, or any action taken or omitted to be taken in reliance on it is prohibited and may be unlawful. If you receive this communication in error, please notify us immediately by telephone call to +1-559-292-1981 or forward the e-mail to [email protected] and then permanently delete the e-mail and destroy all soft and hard copies of the message and any attachments. Thank you for your cooperation. - ---------------------------------------------------------------------------- --
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
