-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 David Brownell wrote: > On Sunday 17 May 2009, Yusuf Caglar AKYUZ wrote: >> Because I couldn't find any UBL implementation which reads u-boot >> from SD Card, or at least mentioning of it. I was pretty sure that >> everything was ok, but I should re-check since you say it works. > > http://sourceforge.net/project/showfiles.php?group_id=233754 > > The 1.50 "DaVinci Serial Boot and Flashing" code has code > for such a UBL -- not built by default though. ISTR that > the "SD card boot and flash utility" code you referenced > is built from older (1.10) versions of that code. > >
Looking at the code, I see no headers named sdmmc.h or sdmmcboot.h, both are referenced from sdmmcboot.c I wonder if this can be compiled. That's an other story though. I started from scratch, still no results. I'm sure RBL boots from SD, but I get no response from the board after that point. I'm checking only serial port but I assume there must be something on my uart. Anyway, I go digging. Thanks, Caglar -----BEGIN PGP SIGNATURE----- Version: GnuPG v2.0.9 (GNU/Linux) Comment: Using GnuPG with SUSE - http://enigmail.mozdev.org iEYEARECAAYFAkoRojoACgkQ/nL+S5dojejCHwCgmdeuY6XvAwIDqSHo71xZu57c 8PYAmQGlYqIzqUbs0hURWC4rWVPRBpNw =NKrI -----END PGP SIGNATURE----- _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
