Hi,
I am trying to use serial boot loader utility and still not able to load
kernel image in DDR. This DDR interface is separately tested. So I guess I
am going somewhere wrong in using this utility.
(I am working on DM646x custom board and trying to load linux in it)
Steps I am following are as follows
1. slh_dm646x.exe -load2DDR UBL_DM646x_NOR.bin
2. slh_dm646x.exe -load2DDR -startADDR 0x80200000 u-boot.bin
3. slh_dm646x.exe -load2DDR -startADDR 0x81000000 uImage
---------------- in this whole process my jumper settings are 1000- UART
MODE
After doing this I just get BOOTME on HyperTerminal.
Am I going wrong somewhere (may be in jumper setting/ sequence of
instructions/ addr etc) ?
Regards,
Onkar Patki,
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
