Hello.
stanley.miao wrote:
Texas Instruments CPPI 4.1 DMA support for the MUSBMHRDC driver.
<snip> ..
Index: linux-davinci/drivers/usb/musb/Makefile
===================================================================
--- linux-davinci.orig/drivers/usb/musb/Makefile
+++ linux-davinci/drivers/usb/musb/Makefile
@@ -53,9 +53,13 @@ ifneq ($(CONFIG_MUSB_PIO_ONLY),y)
musb_hdrc-objs += cppi_dma.o
else
- ifeq ($(CONFIG_USB_TUSB_OMAP_DMA),y)
- musb_hdrc-objs += tusb6010_omap.o
+ ifeq ($(CONFIG_USB_TI_CPPI41_DMA),y)
+ musb_hdrc-objs += cppi41_dma.o
+ ifeq ($(CONFIG_USB_TUSB_OMAP_DMA),y)
+ musb_hdrc-objs += tusb6010_omap.o
+
+ endif
endif
endif
endif
You put the "ifeq($(CONFIG_USB_TUSB_OMAP_DMA),y)" in the
"ifeq ($(CONFIG_USB_TI_CPPI41_DMA),y) ..... endif".
So if CONFIG_USB_TI_CPPI41_DMA is not enabled, tusb6010_omap.c will
not be compiled.
Hum, you're right. The patch is broken -- there should be 'else' there...
Stanley.
WBR, Sergei
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
