From: Mark A. Greer <[email protected]> The DA830/OMAP-L137 EVM cannot use the default pinmux setup for McASP1 so put the correct settings in the board file for that platform.
Signed-off-by: Mark A. Greer <[email protected]> --- arch/arm/mach-davinci/board-da830-evm.c | 11 ++++++++++- 1 files changed, 10 insertions(+), 1 deletions(-) diff --git a/arch/arm/mach-davinci/board-da830-evm.c b/arch/arm/mach-davinci/board-da830-evm.c index 22d9fe4..39711c1 100644 --- a/arch/arm/mach-davinci/board-da830-evm.c +++ b/arch/arm/mach-davinci/board-da830-evm.c @@ -22,6 +22,7 @@ #include <mach/common.h> #include <mach/irqs.h> #include <mach/cp_intc.h> +#include <mach/mux.h> #include <mach/da8xx.h> #include <mach/asp.h> @@ -55,6 +56,14 @@ static struct davinci_uart_config da830_evm_uart_config __initdata = { .enabled_uarts = 0x7, }; +static const short da830_evm_mcasp1_pins[] = { + DA830_AHCLKX1, DA830_ACLKX1, DA830_AFSX1, DA830_AHCLKR1, DA830_AFSR1, + DA830_AMUTE1, DA830_AXR1_0, DA830_AXR1_1, DA830_AXR1_2, DA830_AXR1_5, + DA830_ACLKR1, DA830_AXR1_6, DA830_AXR1_7, DA830_AXR1_8, DA830_AXR1_10, + DA830_AXR1_11, + -1 +}; + static u8 da830_iis_serializer_direction[] = { RX_MODE, INACTIVE_MODE, INACTIVE_MODE, INACTIVE_MODE, INACTIVE_MODE, TX_MODE, INACTIVE_MODE, INACTIVE_MODE, @@ -117,7 +126,7 @@ static __init void da830_evm_init(void) i2c_register_board_info(1, da830_evm_i2c_devices, ARRAY_SIZE(da830_evm_i2c_devices)); - ret = da8xx_pinmux_setup(da830_mcasp1_pins); + ret = da8xx_pinmux_setup(da830_evm_mcasp1_pins); if (ret) pr_warning("da830_evm_init: mcasp1 mux setup failed: %d\n", ret); -- 1.6.2.5.182.ga808d _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
