Jaya krishnan wrote:
Hi
I am unable to insmod the CMEM driver. The parameters Phys_start and
phys_end are not detected, eventhogh I supplied it properly.
At the same time , I am able to insert other modules like dsplink. I do
not suspect any problems with CMEM driver, since the same had been used
earlier successfully. The error message is given below. Pls suggest a
solution
\...@\h:\w\$ ./loadmodules.sh
cmemk: Unknown parameter `"phys_start'
why don't you also post the line that tries to load cmem?
CMEMK Error: Pysical start and end addresses not supplied
insmod: cannot insert 'cmemk.ko': invalid parameter
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
