Sandeep, Thank you for your response. We are using TMS320DM6441ZWT device. Can you suggest any NAND device that will be recognized by RBL and easily available from a supplier/distributor in US?
Regards, Naresh Irvine Sensors Corporation phone: (714)-435-8928 email: [email protected] ________________________________ From: Paulraj, Sandeep [mailto:[email protected]] Sent: Monday, December 07, 2009 2:09 PM To: Naresh Kansara Cc: [email protected] Subject: RE: NAND support of DaVinci We have tried NANDs of large sizes in DM355 and DM365. Before opting for a NAND you should check if the NAND will get detected by the RBL. Also DM6446 supports only 1 bit HW ECC so you should also make sure that the NAND you choose does not require more than I bit ECC. If you satisfy these 2 conditions then you should be able to use NANDs of large sizes. ________________________________ From: [email protected] [mailto:[email protected]] On Behalf Of Naresh Kansara Sent: Monday, December 07, 2009 5:04 PM To: [email protected] Subject: NAND support of DaVinci Hello All, The Spectrum DVEVM board uses a NAND Flash device that is not easily available from supplier/distributor in US. Has someone on his/her custom Davinci board has used a new NAND Flash device that is >= 128Mbytes and easily available from local US supplier? Thank you for help. Naresh Kansara Irvine Sensors Corporation phone: (714)-435-8928 email: [email protected]
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
