Kieran
It is very possible to do what you want. Be prepared for a possible
failure as you figure it out. The address to write to should b
determied from the product documentation. What product are you
using? Also, you can read NAND and display to try and match up the
header and verify it is the correct address.
On a side note, VirtualBox with Windows XP and CCS 3.3 works well with
the SD emulators. You may need that if you brick a unit.
Steve
On May 21, 2010, at 12:02 PM, Kieran Bingham <[email protected]>
wrote:
Hi Guys,
As I'm running linux, I can't easily switch to running Windows for
CCS.
I've been making changes to UBoot and testing them by setting the
TEXT_BASE at a different address in RAM, loading via TFTP, and
calling go $(loadaddr)
Now I would like to write this uboot binary to flash, so I've
recompiled it with the original TEXT_BASE, but I can't figure out
where I need to flash it in the NAND.
Is it possible to reflash uboot from within Uboot?
--
Regards
Kieran
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
