board-da850-evm.c

Nicolas



On Wed, Jul 28, 2010 at 4:51 PM, Todd Fischer <[email protected]>wrote:

>  On Wed, 2010-07-28 at 16:46 -0400, Nicolas Luna wrote:
>
> Todd,
>
>
>
>  What do I need to change if I want to use the bitbang i2c driver and stop
> to get those error messages.
>
>
>
>  I added support for "GPIO-based bitbaging I2C" into the kernel, anything
> else to change in the TPS driver source code?
>
>
> You need to modify the arm/arch/mach-davinci board file to configure the
> pinmux as GPIOs, not I2C signaling.
>
> Which hardware board are you using?
>
>
>
>
>  Thanks
>
>
>
>  Regards,
>
>
>
>  Nicolas
>
>
>
>  On Wed, Jun 9, 2010 at 4:17 PM, Todd Fischer <[email protected]>
> wrote:
>
>  HI Bastian and Nicolas,
>
> I recall getting this error when I wasn't using the bitbang i2c driver on
> the OMAP-L138.
>
> Todd
>
>
>
>
> On Wed, 2010-06-09 at 10:59 +0200, Bastian Ruppert wrote:
>
>
>    Hello Nicolas,
>
> thanks for the .conf file.
>
> > this will help you to check if your hardware is ok.
>
> It helped.
>
> I applied your file on the khilman commit you are using but i had to patch
> the kernel in order to
> compile drivers/mfd/tps6507x.c . I think if you don`t have the same
> problems, that is anomalous.
>
> After that the touchscreen driver is running on that kernel. It`s a little
> bit unstable, there are sometimes errors like
>
> tps6507x 1-0048: TSC mode read failed
> i2c_davinci i2c_davinci.1: controller timed out
> i2c_davinci i2c_davinci.1: initiating i2c bus recovery
> i2c_davinci i2c_davinci.1: controller timed out
> i2c_davinci i2c_davinci.1: initiating i2c bus recovery
>
> but the hardware can in principle do it.
>
> Regards,
>
> Bastian.
>
>    _______________________________________________
> Davinci-linux-open-source mailing list
>
>    [email protected]
> http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
>
>
>
>
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source

Reply via email to