On Tue, 2010-11-30 at 15:32 +0530, Savinay Dharmappa wrote: > From: David Griego <[email protected]> > > OMAP-L137/AM17x has limited number of dedicated EMIFA > address pins, enough to interface directly to an SDRAM. > If a device such as an asynchronous flash needs to be > attached to the EMIFA, then either GPIO pins or a chip > select may be used to control the flash device's upper > address lines. > > This patch adds support for the NOR flash on the OMAP-L137/ > AM17x user interface daughter board using the latch-addr-flash > MTD mapping driver which allows flashes to be partially > physically addressed. The upper address lines are set by > a board specific code which is a separate patch. > > Signed-off-by: David Griego <[email protected]> > Signed-off-by: Aleksey Makarov <[email protected]> > Signed-off-by: Sergei Shtylyov <[email protected]> > Signed-off-by: Savinay Dharmappa <[email protected]>
Pushed these to l2-mtd-2.6.git, thanks. -- Best Regards, Artem Bityutskiy (Битюцкий Артём) _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
