On Mon, Jan 31, 2011 at 1:36 PM, Juha Kuikka <[email protected]> wrote: > On Mon, Jan 31, 2011 at 11:04 AM, Gary Thomas <[email protected]> wrote: >> >> I have a board which is uses the OMAP-L138. It's similar in >> many respects to the EVM/DA850 modules, but there are differences. >> In particular, my board uses MMC/SD1 since it also uses NOR FLASH. >> >> I was able to modify U-Boot to handle this without much trouble. >> However, it doesn't run in Linux. I added the driver bits for >> this, but what I see is that the very first command issued sets >> up for a completion interrupt (which the registers tell me happens), >> but the driver IRQ handler is never called. >> >> Am I alone in this? as I didn't find any support for MMC/SD1 >> in the Linux kernel (I checked the most recent public 2.6.37) >> >> Does anyone have experience using MMC/SD1 on the OMAP-L138 >> with the Linux driver? >> > I think I ran into the same issue. > Check this conversation on the subject, especially the third > mail: http://davinci-linux-open-source.1494791.n2.nabble.com/DA850-and-MMCSD1-EDMA-td5077613.html > I guess I should have pushed that patch but for some reason I never got > Sudhakar's comment on it. :( > If this is the solution to your problem maybe you can refresh it against the > latest kernel and submit it? I don't have access to the HW any more so I > cannot verify it. > - Juha
Hello Juha, Followed the link you provided, it seems that Sudhakar did respond. He suggested you to submit your patch to the davinci mailing list. Regards, Steve _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
