Hello,
The problem with the "all" implementation is that it hogs the ARM/DSP
heavily and that's the reason why we specifically avoided this in our
firmware design.
Hence, implementing this condition spoils the whole purpose of the PRU!!
--------------------------------------------------
From: "Marc Kleine-Budde" <[email protected]>
Sent: Monday, February 14, 2011 3:05 PM
To: "Subhasish Ghosh" <[email protected]>
Cc: "Wolfgang Grandegger" <[email protected]>; "Kurt Van Dijck"
<[email protected]>; <[email protected]>;
<[email protected]>; <[email protected]>;
<[email protected]>; <[email protected]>; "open list:CAN NETWORK
DRIVERS" <[email protected]>; "open list:CAN NETWORK DRIVERS"
<[email protected]>; "open list" <[email protected]>
Subject: Re: [PATCH v2 09/13] can: pruss CAN driver.
Hello,
On 02/14/2011 09:45 AM, Subhasish Ghosh wrote:
That is correct, we receive only pre-programmed CAN ids and "all" or
"range" implementation is not there in the PRU firmware.
I'd really like to see that you add a "all" implementation to the
firmware. Or even better use the standard id/mask approach.
cheers, Marc
--
Pengutronix e.K. | Marc Kleine-Budde |
Industrial Linux Solutions | Phone: +49-231-2826-924 |
Vertretung West/Dortmund | Fax: +49-5121-206917-5555 |
Amtsgericht Hildesheim, HRA 2686 | http://www.pengutronix.de |
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
