ethtool is not supported by davinci-emac? --- On Wed, 4/6/11, r&[email protected] <r&[email protected]> wrote:
> From: r&[email protected] <r&[email protected]> > Subject: PATCH: DaVinci EMAC MII ioctl support > To: [email protected] > Date: Wednesday, April 6, 2011, 9:24 AM > > Dear DaVince developer, > > I'm currently working with a TI AM35xx on our embedded > SOM. > > Due the fact that I need to use mii-tool on our platform > I've done a > little patch to your driver to add mii ioctl support. > > It has been tested on our Lizard board (SMSC LAN8700 as > Ethernet phy) > with the following version of mii-tool: > > root@lizard:/mnt/ubifs# mii-tool -V > mii-tool.c 1.9 2000/04/28 00:56:08 (David Hinds) > eth0: 100 Mbit, full duplex, link ok > > Feel free to add this to patch to the next release of your > driver, I > think it will be useful to many developers. > > Best Regards, > > -- > > Andrea SCIAN > DAVE > www.dave.eu > > > -----Inline Attachment Follows----- > > _______________________________________________ > Davinci-linux-open-source mailing list > [email protected] > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
