On Mon, 2012-04-09 at 16:19 +0530, Manjunathappa, Prakash wrote:
> Reconfigure interrupt coalesce parameter for changed emac bus_freq
> due to DVFS.
> 
> Signed-off-by: Manjunathappa, Prakash <[email protected]>
> ---
>  drivers/net/ethernet/ti/davinci_emac.c |   60 
> ++++++++++++++++++++++++++++++++
>  1 files changed, 60 insertions(+), 0 deletions(-)
> 
> diff --git a/drivers/net/ethernet/ti/davinci_emac.c 
> b/drivers/net/ethernet/ti/davinci_emac.c
> index 174a334..11d3bd7 100644
> --- a/drivers/net/ethernet/ti/davinci_emac.c
> +++ b/drivers/net/ethernet/ti/davinci_emac.c
> @@ -50,6 +50,7 @@
>  #include <linux/ctype.h>
>  #include <linux/spinlock.h>
>  #include <linux/dma-mapping.h>
> +#include <linux/cpufreq.h>
>  #include <linux/clk.h>
>  #include <linux/platform_device.h>
>  #include <linux/semaphore.h>
> @@ -344,6 +345,9 @@ struct emac_priv {
>       /*platform specific members*/
>       void (*int_enable) (void);
>       void (*int_disable) (void);
> +#ifdef CONFIG_CPU_FREQ
> +     struct notifier_block   freq_transition;
> +#endif
>  };
>  
>  /* clock frequency for EMAC */
> @@ -1761,6 +1765,46 @@ static const struct net_device_ops emac_netdev_ops = {
>  #endif
>  };
>  
> +#ifdef CONFIG_CPU_FREQ
> +static int davinci_emac_cpufreq_transition(struct notifier_block *nb,
> +                                  unsigned long val, void *data)
> +{
> +     int ret = 0;
> +     struct emac_priv *priv;
> +
> +     priv = container_of(nb, struct emac_priv, freq_transition);
> +     if (priv->coal_intvl != 0) {
> +             if (val == CPUFREQ_POSTCHANGE) {
> +                     if (emac_bus_frequency != clk_get_rate(emac_clk)) {
> +                             struct ethtool_coalesce coal;
> +
> +                             emac_bus_frequency = clk_get_rate(emac_clk);
> +
> +                             priv->bus_freq_mhz = (u32)(emac_bus_frequency /
> +                                             1000000);
> +                             coal.rx_coalesce_usecs = (priv->coal_intvl
> +                                             << 4);
> +                             ret = emac_set_coalesce(priv->ndev, &coal);
[...]

Ick.  Why don't you break up emac_set_coalesce() so that you can push
this one value to the hardware without faking up a struct
ethtool_coalesce?  Don't you need to push it on reset/resume anyway?

Ben.

-- 
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.

_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source

Reply via email to