On Mon, Apr 24, 2006 at 07:07:24AM +0200, Alex Teclo wrote: > I am trying to install/use Debian GNU/Linux 3.0 woody on a Macintosh > Quadra 700 > > I have tried installing Debian GNU/Linux 3.1 sarge, but there were two > problems: > 1) There is only 20 MB of RAM on the machine (although sarge should > support that)
Yes, but the installation will run _very_ slow then. > 2) The installation of sarge fails always at the same point: when > loading the libc6 from the cdrom / iso file / mounted filesystem. It could be that it's still running at that point, but so slowly that it might take a few _days_ before it finishes the install. Going to woody would indeed seem to be the safer (faster) choice. Note that upgrading from woody to sarge is still possible, and should present no problems, even with your amount of RAM. > So I'm installing woody. > > Well, the installation was successful, but there is one problem: > at boot time, the machine says "Setting the System Clock using the > Hardware Clock as reference..." and then... nothing happens for > several minutes. The only solution I have found is to do Ctrl-C on > this message to skip this step. That is a known issue; with some models, there are problems with the hwclock implementation. I didn't know it occurred on woody as well, but there you go. You can work around the problem by disabling the hwclock invocation entirely; remove the symlinks in /etc/rc*.d that link to /etc/init.d/hwclockfirst.sh or /etc/init.d/hwclock.sh. Only make sure to keep at least one of them there, though it should then be one that isn't invoked (if you don't do that, the symlink will be restored the next time you upgrade util-linux) -- Fun will now commence -- Seven Of Nine, "Ashes to Ashes", stardate 53679.4 -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
