Happy new year to everyone ! I have some troubles to use my PWS500 on a 100 baseTX network. Under SRM, I have forced the network card to use the FastFD mode. But when the kernel boot up, the card switches to 10 baseT/Full duplex mode.
Following, there is some logs : Under SRM, the 'sh conf' command says : >Digital Semiconductor 21143 Network Controller > ewa0.0.0.3.0 and 'sh ewa0_mode' says : > ewa0_mode FASTFD 'dmesg' says : >tulip.c:v0.91g-ppc 7/16/99 [EMAIL PROTECTED] >eth0: Digital DS21143 Tulip rev 48 at 0x8000, 00:00:F8:76:40:75, IRQ 24. >eth0: EEPROM default media type Autosense. >eth0: Index #0 - Media 10baseT (#0) described by a 21142 Serial PHY (2) block. >eth0: Index #1 - Media 10baseT-FD (#4) described by a 21142 Serial PHY (2) >block. >eth0: Index #2 - Media 10base2 (#1) described by a 21142 Serial PHY (2) block. >eth0: Index #3 - Media AUI (#2) described by a 21142 Serial PHY (2) block. >eth0: Index #4 - Media MII (#11) described by a 21142 MII PHY (3) block. >eth0: MII transceiver #5 config 2100 status 784b advertising 01e1. >eth0: Advertising 0061 on PHY 5, previously advertising 01e1. >eth0: Advertising 0061 (to advertise is 0060). >eth1: region already allocated at 0x8000. >(...) >eth0: Setting full-duplex based on MII#5 link partner capability of 41e1. If someone has an idea ? Thanks... Pierre -- ............................................................................ .Pierre ROUSSEL . [EMAIL PROTECTED] . . . . .Centre d'Etudes de la Navigation Aerienne . . .Division Support Informatique et D�veloppement . Phone: 01 69 57 64 33 . .Orly Sud 205 . Fax: 01 69 57 63 52 . .94542 ORLY AEROGARE CEDEX, FRANCE . . ............................................................................
