On Fri, Feb 06, 2004 at 11:22:41AM -0500, mel kravitz wrote: > > I used swriteboot to install 0.9b after building it from > src(.tar.gz).Tested disk for boot on an as1200 and ds10-both(ok). > I build all my kernels and quite a few programs from > src, never had a problem before. > > On the ds15-> > boot dka0 -fl a ,jumps to aboot prompt.thats not > the problem here, i will be more specific:(from aboot prompt) > b 4/vmlinuz-2.4.24 root=/dev/sda4 gives: > ....booting starts normally.. then aborts with: > Kernel Stack not valid halt > PC=0 > Error detected by Pchip0 > APerror=002000000003b8101 > lost error > no devsel > ------ > repeated with 2.6.2 kernel gives same SRM console errors.. > I will check with HP SRM guys see what they say..report what i find.
OK, I finally got my hands on a DS15 to play with, and here's what I saw: - 2.4.24 kernel booted and seemed fine. - 2.6.2 kernel booted and seemed fine. HOWEVER, these were ONLY true when: a. the kernels were configured WITHOUT "AGP". b. the kernels were run ONLY from SERIAL CONSOLE. The kernel configurations must NOT include the AGP option because the core_titan.c:titan_agp_info() code expects there to be two PA chips, and when there is only one (as in DS15), a machine check will occur at a time when it isn't easily handled. This is a bug and will be fixed for the next versions. The kernels must be run from/to SERIAL CONSOLE, because the PCI bus with slots, where a graphics card would be installed, is NOT on hose #0, and those kernels do NOT include code which can handle this situation. This is NOT a bug, as such; it is a kernel limitation that VGA devices MUST live on a PCI bus on hose #0. This is primarily because of all the legacy device addresses used throughout the kernel to refer to VGA registers and memory. When the VGA is NOT on hose #0, those legacy addresses will not respond. The patches to accomplish this have, in the past, been deemed too intrusive on non-Alpha-architecture files to be allowed into the official sources. Both of these problems do not occur with the kernels released as part of the Red Hat 7.2 for Alpha distribution (including updates), so one can choose to run one of them, or use the sources to port the necessary fixes to the desired destination. Sorry about the delay in getting this info out... Good luck. --Jay++ ----------------------------------------------------------------------------- Jay A Estabrook HPTC - LINUX support Hewlett-Packard Company - MRO1-2/K15 (508) 467-2080 200 Forest Street, Marlboro MA 01752 [EMAIL PROTECTED] -----------------------------------------------------------------------------
