Hi Dan,
use the modconf Programm to configure your modules or change the
e100-entry in /etc/modules to eepro100.
Hope that'll help.
Martin
Dan Cernese schrieb:
I did a clean netinst/sarge install on a DS20L and found that the default e100
driver
was highly unstable. It would operate fine for a short time, but whenever
any amount of data was transferred (a few MB), it simply stopped without
error. Doing an ifdown/ifup makes it work again.
I found by chance that if I removed e100 and added eepro100,
it runs normally. (rmmod e100; modprove eepro100)
How do I make this permanent/across reboots?
_____________________________________________________________________
Dan Cernese dan.cernese<at>hp.com
Hewlett-Packard Company phone: +1 (603) 884-0289
110 Spit Brook Road ZKO1-3/H41 FAX: +1 (603) 884-5110
Nashua, New Hampshire 03062-2698 dhcernese<at>alum.wpi.edu
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
