From: David Sawyer <[EMAIL PROTECTED]> Reply-To: David Sawyer <[EMAIL PROTECTED]> To: [email protected] Subject: Re: AMD64 DHCP Network Configuration Failure Date: Mon, 17 Jan 2005 14:58:30 -0500
On Mon, 17 Jan 2005 18:37:21 +0000, Pat C <[EMAIL PROTECTED]> wrote:
> I just put a new system together. Here are the specs:
>
> AMD64 3200+ CPU
> 512MB DDR 3200 RAM
> 3DFX 16MB Graphics Card... old, yes I know :)
> Standard CD-Drive
> 20GB IDE Hard Drive
> 550 Watt Power Supply
> Antec Case
> Bridgecom 10/100 Fast Ethernet NIC
> DFI LANPARTY UT nF3 250Gb nForce3 250GB Chipset Motherboard (onboard
> 10/100/1000 Ethernet, Audio, USB, and Firewire)
>
> I am using the SargeAMD64 NetInstall .ISO Everything works until I get to
> the network configuration section. My Bridgecom 10/100 card shows up, as
> well as firewire (eth1). However, my onboard ethernet on the motherboard
> doesn't. Ok I think, I'll just use the older one for now. It goes to get
> DHCP information and can't do it. I put in my hostname and it still can't
> do it. When I go to configure it manually to see if it works, I put in all
> the information and then the system goes blank.
What do you do to configure it manually. Did you edit the /etc/network/interfaces file, or just type ifconfig eth0 ip netmask netmask_addr.
No, this is during the installation process. There is an option that allows you to manually put in an IP address and gateway and so on. Is there a way to see the linux unpack and load before it gets to choosing a language? It scrolls by too fast for me to read.
When exactly does the system go blank. During startup if you changed the above file I mentioned, or after using ifconfig?
When I try putting the values in manually, I put in the IP address, netmask, gateway, and nameserver. AHHh... ok, I think I figured it out. If you put in a nameserver and you're not using a nameserver (me) then it hangs. I left the nameserver out and it worked and continued on to the hostname setup. I think it would be beneficial to add a check so that if the nameserver doesn't work it can continue on without one. This might confuse people. Also there is a default value in the nameserver. Maybe just leave it blank? I will continue with the installation and see if I can configure DHCP from the commandline. Thank you.
Can you do anything when it goes blank, try switching consoles or Ct-alt-del it. Or Is the system hard frozen?
>I know everything should
> work because I tried an old version of Debian for i386 and it could find
> everything for DHCP easily. Does anyone have any suggestions? Could this
> be a bug? Thank you for the help. :)
DHCP seems like less of a problem as the system blanking when you try to configure it. If the network card and module are working, you can run dhclient anytime.
>
> --
> To UNSUBSCRIBE, email to [EMAIL PROTECTED]
> with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
>
>
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
