Hello all,
I am looking for two solutions with wireless cards. I have a Broadcom bcm4318
and a realtek rtl8169.
- How can I force to use eth0 for the wlan-card, and eth1 for the
hardwired-card ? I use udev, so sometimes theezh0 and eth1 changes at
starting. Hardwired shall have a fixed IP, wlan shall get the ip with dhcp.
- How can I force to use 11MBit on the wlan-card. The wlan-card originally
always is using 54MBit. This my entry in /etc/network/interfaces, but this
does not work:
# The primary network interface
auto eth0 eth1
iface eth0 inet dhcp
wireless-essid myssid
wireless-channel 6
wireless-key XXXXXXXXX
wireless-mode managed
wireless-rate 11M <--- This should change the rate
iface eth1 inet static
address xxx.xxx.xxx.y
netmask yyy.yyy.yyy.z
network xxx.xxx.xxx.0
broadcast xxx.xxx.xxx.255
gateway xxx.xxx.xxx.x
Best regards
Hans
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
