C M Reinehr wrote: > On Wednesday 26 September 2007 09:21, Dave Ewart wrote: > > On Wednesday, 26.09.2007 at 09:49 -0400, Scott Lair wrote: > > > I tried to install Etch on AMD64 using raid level 10. After I > > > partitioned the drives, I went to create the md devices and could only > > > choose from raid levels 0,1 or 5. Should I be able to install with > > > level 10? I tried the latest netinst.iso and the cdrom install disk 1 > > > with the same results. > > > > There is no direct support for RAID-10 via software RAID, you have to > > make yourself two RAID-1 arrays and then apply a second layer of > > software RAID-0 over the top. > > > > The installer may not support RAID-10 directly because of the > > multi-layer approach. > > > > Normally, one makes a RAID-10 software setup as follows: > > > > mdadm --create /dev/md0 --level=1 --raid-devices=2 /dev/sd[ab]1 > > mdadm --create /dev/md1 --level=1 --raid-devices=2 /dev/sd[cd]1 > > mdadm --create /dev/md2 --level=0 --raid-devices=2 /dev/md[01] > > > > I'd be interested to know if you can approach the installation in the > > same way, actually. > > > > Dave. > > That's not entirely true. Etch does support RAID-10, just not the installer. > What I would suggest is first to do a minimal installation to a small RAID-1 > partition, including GRUB to the MBR. Then, once you have booted into this > system, use the system tools (cfdisk, mdadm, & lvm) to set up the rest of the > drive(s) as RAID-10 (with or without LVM). Then, do a debootstrap > installation of a complete system into this. Finally, your RAID-1 partition > becomes your /boot partition. Not the most direct route, but it works. > That sounds like what I would like to do. So the original installation gets removed once the RAID-10 install is done correct? I'm wondering about the size of the initial installation partition. I generally make /boot about 200Meg. Do you think that would be enough for a minimal or should I go bigger?
thanks much, scott -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
