Dear Folks, I have now fixed this problem.
The new nvidia glx driver that goes with the 25.2 kernel actually has a 1360 x 768 module that is invoked for my TLU 03732B LCDTV.... The Xorg log file says that the nvidia card is using this module to drive the monitor. So I think I am now running at the full resolution of this device. Thanks Michael Fothergill P.S. I am driving the LCDTV with a vga cable. This works OK. I have however bought myself a DVI-D to HDMI cable. I tried to use this to drive the LCDTV instead of the vga cable. I connected it to the DVI output on the Nvidia card.......... But the screen stayed blank. Is there a magical command I need to stick in the xorg file to tell the nvidia card to send a signal down the DVI cable???? Suggestions welcome. Regards Michael Fothergill ---------------------------------------- > From: [EMAIL PROTECTED] > To: [email protected] > Subject: RE: kernel upgrade has made nvidia 3D rendering not turn on..... > Date: Sun, 1 Jun 2008 07:59:44 +0000 > > > > ---------------------------------------- >> Date: Sun, 1 Jun 2008 17:34:22 +1000 >> From: [EMAIL PROTECTED] >> To: [EMAIL PROTECTED] >> CC: [email protected] >> Subject: Re: kernel upgrade has made nvidia 3D rendering not turn on..... >> >> boot the previous kernel version for a while >> >> Dean > > Please excuse my ignorance here but how exactly does one do that? > > MF > > > > _________________________________________________________________ > > http://clk.atdmt.com/UKM/go/msnnkmgl0010000009ukm/direct/01/ > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > _________________________________________________________________ http://clk.atdmt.com/UKM/go/msnnkmgl0010000002ukm/direct/01/ -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
