Hello again:
I did a few tests on a Pentium 4 1.8GHz machine with 512 of RAM. The
compilation of the cmd.cpp module took about 2 minutes and used over 300MB
of memory. Some other modules were up above 200MB. i double checked with
the previous version of the package, 0.5.1, and discovered that it never
required much over 100MB during compilation of any one module. It turns
out that bewteen the two versions, the upstream author changed from a
felx/bison command parser to a pure C++ one and this is the cmd.cpp module
which is problematic.
I don't know how the arm and mipsel buildds will handle this kind of load
with other processes going on too.
Carlo
On Thu, 16 Mar 2006, Martin Michlmayr wrote:
* Carlo Segre <[EMAIL PROTECTED]> [2006-03-16 00:50]:
I am a bit at a loos as to how to figure out this problem. My
package, fityk, builds fine on all architectures except mipsel and
arm [0].
Ryan, can you please requeue fityk on mipsel and arm.
I just built it on SWARM/mipsel - cmd.cpp only took a few minutes and
the whole package about half an hour.
I think this was some transient problem.
--
Carlo U. Segre -- Professor of Physics
Associate Dean for Special Projects, Graduate College
Illinois Institute of Technology
Voice: 312.567.3498 Fax: 312.567.3494
[EMAIL PROTECTED] http://www.iit.edu/~segre
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
