Martin Michlmayr schrieb: > * Steve Wagner <[EMAIL PROTECTED]> [2008-08-06 17:17]: >> Set slug is set to an static ip adress, but i dont know where i dose >> this. So i can not check if the data is correct. But the SlugOSLE >> image boots after flashing without changes on the network >> configuration and is available on the network address i set before. >> >> How can i get the debian 5.0beta2 to boot? > > Isn't this essentially the same message you posted to the nslu2-linux? > I'm not sure why you'll get better responses here.
Sorry for the double post, but it did get there no answers, only questions and i am not sure which list is best for such a question.
> The most likely explanation is that your static network configuration > is not complete. If this is the case, the installer will not start. > There might be other reasons but without a serial console it's > impossible to say. > > The network configuration is stored in a MTD partition called SysConf. > You should be able to change the network configuration with SlugOS > (either complete the static config, or change it to use DHCP) and then > to flash debian-installer again. Thx for that information. I will try to change that and flash again. Steve -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
