Hi JF , Which kernel you are using to boot ,can you send to me
I am using the kernel 2.6.27.8, but got some error when load the kernel modules . Thanks On Wed, Aug 5, 2009 at 8:16 AM, JF Straeten <[email protected]> wrote: > > Hi, > > On Fri, Jul 31, 2009 at 05:49:37PM +0200, Martin Michlmayr wrote: > > > > As a side note, the results are exactly the same with the Lenny kernel > > > (2.6.26) which boots if tftp loaded, but not when flashed. > > > > Strange... I don't have the hardware so I cannot track this down, but > > I'm sure Wouter will take a look. > > I finaly get my SS4000-E booting ! :-) > > In fact, everything needed is in Wouter's notes in the manual : one > should not forget to update the boot script on the nas after flashing > the kernel. > > Until now, I leave it untouched and it was the only remaining problem. > > But where the final ยง says : > > Note that it is not necessary to update the boot script after the > installation. The system will be configured to take the root > device from system configuration, rather than from the kernel > command line. It will not do any harm to do so anyway, however. > > I had nevertheless to explicitly write the used root device in the > script (if not, the kernel waits for the root device). > > The nas is running squeeze (sid wasn't installable the day I retry) > and it get the kernel flashed with the sid flash-kernel package. > > So, a big thanks to all of you --- Arnaud, Martin, Andrea, Wouter and > Kenny --- whose helped me !! > > > -- > > J.-F. STRAETEN > > --- > Mutt 1.5.18 - Debian GNU/Linux > > > -- > To UNSUBSCRIBE, email to [email protected] > with a subject of "unsubscribe". Trouble? Contact > [email protected] > > -- Kenny Kwok
