Hi guys, I'm trying to power up my Sheeva Plug (which is configured to boot Martin's debian from USB drive) with my USB drive connected over an USB hub with other devices on it (i.e Usb headset).
Uboot identifies the devices connected but does not recognize my USB drive and get stuck. This is what I see from my terminal: ======================= TERMINAL OUTPUT ========================= U-Boot 1.1.4 (May 13 2009 - 13:10:52) Marvell version: 3.4.16 U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CF100 Soc: 88F6281 A0 (DDR2) CPU running @ 1200Mhz L2 running @ 400Mhz SysClock = 400Mhz , TClock = 200Mhz DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6 DRAM CS[0] base 0x00000000 size 256MB DRAM CS[1] base 0x10000000 size 256MB DRAM Total size 512MB 16bit width Flash: 0 kB Addresses 8M - 0M are saved for the U-Boot usage. Mem malloc Initialization (8M - 7M): Done NAND:512 MB CPU : Marvell Feroceon (Rev 1) Streaming disabled Write allocate disabled USB 0: host mode PEX 0: interface detected no Link. Net: egiga0 [PRIME], egiga1 Hit any key to stop autoboot: 0 (Re)start USB... USB: scanning bus for devices... USB device not responding, giving up (status=20) 4 USB Device(s) found scanning bus for storage devices... ======================= TERMINAL OUTPUT ========================= Does anyone know how to boot my system without removing other stuff from my usb hub? Thanks for your attention. Regards, Douglas -- To UNSUBSCRIBE, email to debian-arm-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org