So, basically, I must stop the startup sequence at a point where I can gain access to the Redboot prompt. Then issue the commands you suggested, right?
Questions: 1. where do I find/how can I generate such a kernel? 2. what happens to my device after doing this test? Will it revert to normal after a power-cycle or do those command overwrite the flash/disk somehow? Thanks, -c On Thu, Feb 18, 2010 at 3:30 PM, Arnaud Patard <[email protected]> wrote: > Mello <[email protected]> writes: > > Hi, > >> Hi Arnaud and all, >> sorry for the long wait but I've been traveling (for work). >> >> Please find attached the requested data. I believe I've taken the >> entire boot log. >> Also I've run a few commands to explore /proc filesystem. > > From what I can see from the 2 files, your nas looks very similar to the > ep80219 board from intel (bootloader & pci informations). From a quick > look, I only see e100 device replaced with a e1000. I can't be sure > about the crystal frequency (33.3MHz vs 30MHz) but that should not > prevent things to boot. > > You can try booting a kernel with ep80219 support and looks what's > happening. Unfortunately, you can't use debian iop32x kernel packages as > iirc, they don't have the iq31244 option enabled. > > Please, note that you'll have to add 'force_ep80219' on the kernel command > line. For instance : > > fis load ramdisk.gz > <redboot command to load your kernel at 0x01008000> > exec -c "console=ttyS0,115200 rw root=/dev/ram0 init=/linuxrc > initrd=0xa1800000,8M mem=2...@0xa0000000 force_ep80219" > > > Arnaud > -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected] Archive: http://lists.debian.org/[email protected]
