Hi all,
I have a setup on ARM946E that works well for loading and booting
uClinux, and during the boot phase I can stop and single-step kernel.
But once booted, when it gives prompt, pressing CTRL-C in GDB can not
halt the board :
^CHalt timed out, wake up GDB.
Program received signal SIGINT, Interrupt.
stext () at arch/arm/kernel/head-nommu.S:40
40 ldr r1, =machine_arch_type
@ find the machine type
(gdb)
And messages from OpenOCD are these :
Info : Halt timed out, wake up GDB.
Warn : target not halted
Warn : ThumbEE -- incomplete support
Do you have any ideas what is happening ? I suspected on low-power
mode, but uClinux does not enter it (I think).
Best regards,
Drasko
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]
Archive:
http://lists.debian.org/[email protected]
