Peter Bauer wrote (ao): > Is there anywhere a guide how to > install Debian on the Arndale board ?
Follow the instructions at https://wiki.linaro.org/Boards/Arndale/Setup/EnterpriseUbuntuServer to make the arndale boot from sdhc. Use multistrap on a different debian system to put an initial debian on a partition created a bit from the beginning of the sdhc: arndale:~# fdisk -l /dev/mmcblk1 Disk /dev/mmcblk1: 15.9 GB, 15931539456 bytes 149 heads, 49 sectors/track, 4261 cylinders, total 31116288 sectors Units = sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disk identifier: 0x00000000 Device Boot Start End Blocks Id System /dev/mmcblk1p1 25165824 29360127 2097152 83 Linux multistrap.conf: --- [General] arch=armhf directory=/mnt/ cleanup=true noauth=true unpack=true debootstrap=Arndale aptsources=Arndale [Arndale] packages=apt iproute source=http://ftp.nl.debian.org/debian omitdebsrc=true keyring=debian-archive-keyring suite=sid --- After the multistrap, give root a password and create /etc/{fstab,resolv.conf,hostname,hosts,inittab}: arndale:~# cat /etc/{fstab,resolv.conf,hostname,hosts,inittab} LABEL=sdhc / ext4 defaults 0 0 proc /proc proc defaults 0 0 sysfs /sys sysfs defaults 0 0 tmpfs /tmp tmpfs defaults 0 0 tmpfs /run tmpfs defaults 0 0 devpts /dev/pts devpts defaults 0 0 nameserver xx.xx.xx.xx arndale 127.0.0.1 localhost ::1 localhost xx.xx.xx.xx arndale id:2:initdefault: si::sysinit:/etc/init.d/rcS l0:0:wait:/etc/init.d/rc 0 l1:1:wait:/etc/init.d/rc 1 l2:2:wait:/etc/init.d/rc 2 l3:3:wait:/etc/init.d/rc 3 l4:4:wait:/etc/init.d/rc 4 l5:5:wait:/etc/init.d/rc 5 l6:6:wait:/etc/init.d/rc 6 z6:6:respawn:/sbin/sulogin 7:123:respawn:/sbin/getty 115200 ttySAC2 Hope that helps. Sander -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected] Archive: http://lists.debian.org/20130311092234.GB19516@panda
