Package: installation-reports Boot method: CDRW media in a CD-ROM drive Image version: http://cdimage.debian.org/cdimage/squeeze_di_alpha1/i386/iso-cd/debian-testing-i386-netinst.iso Date: 2010-05-29 18:00
Machine: Desktop PC with Gigabyte GA-586TX3 motherboard ( http://www.gigabyte.com/products/product-page.aspx?pid=1574 ) Processor: # cat /proc/cpuinfo processor : 0 vendor_id : AuthenticAMD cpu family : 5 model : 0 model name : 05/00 stepping : 1 cpu MHz : 100.221 fdiv_bug : no hlt_bug : no f00f_bug : no coma_bug : no fpu : yes fpu_exception : yes cpuid level : 1 wp : yes flags : fpu vme de pse tsc msr cx8 pge bogomips : 200.44 clflush size : 32 power management: Memory: 64MB # cat /proc/meminfo MemTotal: 60948 kB MemFree: 10920 kB Buffers: 652 kB Cached: 40372 kB SwapCached: 0 kB Active: 25332 kB Inactive: 18284 kB Active(anon): 2688 kB Inactive(anon): 0 kB Active(file): 22644 kB Inactive(file): 18284 kB Unevictable: 0 kB Mlocked: 0 kB HighTotal: 0 kB HighFree: 0 kB LowTotal: 60948 kB LowFree: 10920 kB SwapTotal: 0 kB SwapFree: 0 kB Dirty: 4 kB Writeback: 0 kB AnonPages: 2616 kB Mapped: 2048 kB Slab: 4240 kB SReclaimable: 2412 kB SUnreclaim: 1828 kB PageTables: 292 kB NFS_Unstable: 0 kB Bounce: 0 kB WritebackTmp: 0 kB CommitLimit: 30472 kB Committed_AS: 5564 kB VmallocTotal: 966648 kB VmallocUsed: 1292 kB VmallocChunk: 964416 kB HugePages_Total: 0 HugePages_Free: 0 HugePages_Rsvd: 0 HugePages_Surp: 0 Hugepagesize: 4096 kB DirectMap4k: 4096 kB DirectMap4M: 61440 kB Partitions: This state is shown after I booted the system from CD in rescue mode: # fdisk -l Disk /dev/hdb: 1281 MB, 1281982464 bytes 255 heads, 63 sectors/track, 155 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Disk identifier: 0x000c6a25 Device Boot Start End Blocks Id System /dev/hdb1 * 1 140 1124518+ 83 Linux /dev/hdb2 141 155 120487+ 5 Extended /dev/hdb5 141 155 120456 82 Linux swap / Solaris # cat /proc/partitions cat /proc/partitions major minor #blocks name 3 64 1251936 hdb 3 65 1124518 hdb1 3 66 1 hdb2 3 69 120456 hdb5 Output of lspci -knn (or lspci -nn): # lspci -knn 00:00.0 Host bridge [0600]: Intel Corporation 430TX - 82439TX MTXC [8086:7100] (rev 01) 00:07.0 ISA bridge [0601]: Intel Corporation 82371AB/EB/MB PIIX4 ISA [8086:7110] (rev 01) 00:07.1 IDE interface [0101]: Intel Corporation 82371AB/EB/MB PIIX4 IDE [8086:7111] (rev 01) Kernel driver in use: PIIX_IDE 00:07.2 USB Controller [0c03]: Intel Corporation 82371AB/EB/MB PIIX4 USB [8086:7112] (rev 01) Kernel driver in use: uhci_hcd 00:07.3 Bridge [0680]: Intel Corporation 82371AB/EB/MB PIIX4 ACPI [8086:7113] (rev 01) 00:09.0 VGA compatible controller [0300]: S3 Inc. 86c764/765 [Trio32/64/64V+] [5333:8811] (rev 54) 00:0a.0 Ethernet controller [0200]: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ [10ec:8139] (rev 10) Subsystem: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ [10ec:8139] Kernel driver in use: 8139too 00:0b.0 USB Controller [0c03]: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller [1106:3038] (rev 50) Subsystem: First International Computer, Inc. Device [0925:1234] Kernel driver in use: uhci_hcd 00:0b.1 USB Controller [0c03]: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller [1106:3038] (rev 50) Subsystem: First International Computer, Inc. Device [0925:1234] Kernel driver in use: uhci_hcd 00:0b.2 USB Controller [0c03]: VIA Technologies, Inc. USB 2.0 [1106:3104] (rev 51) Subsystem: First International Computer, Inc. Device [0925:1234] Kernel driver in use: ehci_hcd Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot: [O] Detect network card: [O] Configure network: [ ] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Install base system: [O] Clock/timezone setup: [ ] User/password setup: [O] Install tasks: [O] Install boot loader: [E] Overall install: [ ] Comments/Problems: I used the netinst CD image with the following version identifier: This is a Debian 6.0 (squeeze) installation CD-ROM. It was built 20100217-22:18; d-i 20100211. I haven't connected the network for the first time just let the installation process go from CD. The grub-pc was installed. After rebooting the system prints the a short grub message line and resets immediately. This repeats until I boot again from CD. The drive setup is as follows: Primary master: none Primary slave: hard disk Secondary master: CD-ROM drive Secondary slave: none -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected] Archive: http://lists.debian.org/[email protected]
