Your message dated Sun, 20 Mar 2011 18:30:42 +0000
with message-id <[email protected]>
and subject line
has caused the Debian Bug report #609466,
regarding [SPARC] console [tty0] enabled, bootconsole disabled
to be marked as done.
This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.
(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact [email protected]
immediately.)
--
609466: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=609466
Debian Bug Tracking System
Contact [email protected] with problems
--- Begin Message ---
Package: installation-reports
Boot method: <How did you boot the installer? CDImage version: <Full URL to
image you downloaded is best>
http://cdimage.debian.org/debian-cd/5.0.7/sparc/iso-cd/debian-507-sparc-CD-1.isoDate:
<Date and time of the install> 2011-01-09
Machine: <Description of machine (eg, IBM Thinkpad R32)> Sun Sparc Ultra 10
Processor: Ultra SPARC IIi 333 MHZ
Memory: 1GB
Partitions: <df -Tl will do; the raw partition table is preferred> ? didn't go
that far
Output of lspci -knn (or lspci -nn): didn't go that far
Base System Installation Checklist: E
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [ ]
Detect network card: [ ]
Configure network: [ ]
Detect CD: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Install base system: [ ]
Clock/timezone setup: [ ]
User/password setup: [ ]
Install tasks: [ ]
Install boot loader: [ ]
Overall install: [ ]
Comments/Problems:
<Description of the install, in prose, and any thoughts, comments
and ideas you had during the initial install.>
start to boot and prints lots of messages on screen, but then stopsthe last
messages are[0.000000] Booting Linux...[0.000000] Built 1 zonelists in Zone
order, mobility grouping on. Total pages: 130071[0.000000] Kernel command
line:[0.000000] PID hash table entries: 4096 (order: 12, 32768 bytes)[0.000000]
clocksource: mult[300c5] shift[16][0.000000] clockevent: mult[553f7ced]
shift[32][42.966816] Console: colour dummy device 80x25[43.020133] console
handover: boot [earlyprom0] -> real [tty0]after this nothing seems to happen I
have previously been running Sarge and FreeBSD 8.1 so the hardware should be
fine.rescue mode has the same problem, expert mode has the same problem The
following image has a similar problem, the error message is a bit different,
but stops when doing something with the
consolehttp://cdimage.debian.org/debian-cd/5.0.7/sparc/iso-cd/debian-507-sparc-businesscard.isolast
line is: [0.000000] console [tty0] enabled, bootconsole disabled
--- End Message ---
--- Begin Message ---
Fixed in Debian 6.0.1 full images with linux-2.6_2.6.32-31.
--- End Message ---
