Hi, I regularly install Debian on qnap NAS TS 212 and TS 412 using the debian installer from the following address:
http://d-i.debian.org/daily-images/armel/daily/kirkwood/network-console/qnap/ Unfortunatly, the installer does not work with the last version of the qnap model TS-212P shipped in december 2013. I plug a serial console on the qnap to see what is wrong. The kernel is successfully loaded and uncompressed but not run. Here is the console output: __ __ _ _ | \/ | __ _ _ ____ _____| | | | |\/| |/ _` | '__\ \ / / _ \ | | | | | | (_| | | \ V / __/ | | |_| |_|\__,_|_| \_/ \___|_|_| _ _ ____ _ | | | | | __ ) ___ ___ | |_ | | | |___| _ \ / _ \ / _ \| __| | |_| |___| |_) | (_) | (_) | |_ \___/ |____/ \___/ \___/ \__| ** LOADER ** ** MARVELL BOARD: DB-88F6282A-BP LE TS-212P ,PHY=1.8v U-Boot 1.1.4 (Aug 2 2013 - 20:51:17) Marvell version: 3.5.3 U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CD5C0 Soc: MV88F6282 Rev 1CPU running @ 1600Mhz L2 running @ 533Mhz SysClock = 533Mhz , TClock = 200Mhz DRAM (DDR3) CAS Latency = 7 tRP = 7 tRAS = 20 tRCD=7 DRAM CS[0] base 0x00000000 size 512MB DRAM Total size 512MB 16bit width Addresses 8M - 0M are saved for the U-Boot usage. Mem malloc Initialization (8M - 7M): Done [16384kB@f8000000] Flash: 16 MB CPU : Marvell Feroceon (Rev 1) USB 0: host mode PEX 0: interface detected no Link. PEX 1: PCI Express Root Complex Interface PEX interface detected Link X1 Reset IDE: Marvell Serial ATA Adapter Integrated Sata device found Net: egiga0 [PRIME] Hit any key to stop autoboot: 0 Send Cmd : 0x68 to UART1 ## Booting image at 00800000 ... Image Name: Debian kernel Created: 2014-01-17 5:56:39 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1929800 Bytes = 1.8 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK OK Starting kernel ... Uncompressing Linux... done, booting the kernel. The qnap is flashing red, no ping to the network. This is also true for previous versions on debian installer. Does anyone have any idea of what is wrong? Gil. -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected] Archive: http://lists.debian.org/[email protected]
