14:51 07.03.02 BIOS-provided physical RAM map: BIOS-e820: 0009f000 @ 00000000 (usable) BIOS-e820: 0ff00000 @ 00100000 (usable) Detected 266682 kHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 532.48 BogoMIPS Memory: 256892k/262144k available (1744k kernel code, 412k reserved, 2940k data, 156k init) Dentry hash table entries: 32768 (order 6, 256k) Buffer cache hash table entries: 262144 (order 8, 1024k) Page cache hash table entries: 65536 (order 6, 256k) VFS: Diskquotas version dquot_6.4.0 initialized Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. 512K L2 cache (4 way) CPU: L2 Cache: 512K CPU: Intel Pentium II (Deschutes) stepping 02 Checking 386/387 coupling... OK, FPU using exception 16 error reporting. Checking 'hlt' instruction... OK. Checking for popad bug... OK. POSIX conformance testing by UNIFIX mtrr: v1.35a (19990819) Richard Gooch (rgooch@atnf.csiro.au) PCI: PCI BIOS revision 2.10 entry at 0xfda03 PCI: Using configuration type 1 PCI: Probing PCI hardware Linux NET4.0 for Linux 2.2 Based upon Swansea University Computer Society NET3.039 NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP TCP: Hash tables configured (ehash 262144 bhash 65536) Starting kswapd v 1.5 Detected PS/2 Mouse Port. Serial driver version 4.27 with<4>keyboard: Timeout - AT keyboard not present? no serial options enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A pty: 256 Unix98 ptys configured Real Time Clock Driver v1.09 RAM disk driver initialized: 16 RAM disks of 4096K size loop: registered device at major 7 PIIX4: IDE controller on PCI bus 00 dev 39 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xfcd0-0xfcd7, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xfcd8-0xfcdf, BIOS settings: hdc:pio, hdd:pio hda: IBM-DADA-26480, ATA DISK drive hdb: TOSHIBA CD-ROM XM-1902B, ATAPI CDROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: IBM-DADA-26480, 6194MB w/460kB Cache, CHS=839/240/63 hdb: ATAPI 24X CD-ROM drive, 128kB Cache Uniform CD-ROM driver Revision: 3.11 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8 scsi: Detection failed (no card) NCR53c406a: no available ports found sym53c416.c: Version 1.0.0 Failed initialization of WD-7000 SCSI card! IBM MCA SCSI: Version 3.2 IBM MCA SCSI: No Microchannel-bus present --> Aborting. This machine does not have any IBM MCA-bus or the MCA-Kernel-support is not enabled! megaraid: v1.11 (Aug 23, 2000) aec671x_detect: 3w-xxxx: tw_findcards(): No cards found. scsi : 0 hosts. scsi : detected total. Partition check: hda: hda1 hda2 hda3 hda4 < hda5 hda6 > apm: BIOS version 1.2 Flags 0x03 (Driver version 1.13) apm: disabled on user request. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 156k freed NET4: Unix domain sockets 1.0 for Linux NET4.0. Adding Swap: 211640k swap-space (priority -1) Soundblaster audio driver Copyright (C) by Hannu Savolainen 1993-1996 SB 3.01 detected OK (220) ESS chip ES1869 detected sb: Interrupt test on IRQ7 failed - Probable IRQ conflict Linux PCMCIA Card Services 3.1.22 kernel build: 2.2.19 #1 Sat May 19 10:59:03 EST 2001 options: [pci] [cardbus] [apm] PCI routing table version 1.0 at 0xfdf80 00:14.0 -> irq 9 00:14.1 -> irq 9 Intel PCIC probe: TI 1250A rev 02 PCI-to-CardBus at slot 00:14, mem 0x68000000 kernel build: 2.2.19 #1 Sat May 19 10:59:03 EST 2001 options: [pci] [cardbus] [apm] PCI routing table version 1.0 at 0xfdf80 00:14.0 -> irq 9 00:14.1 -> irq 9 Intel PCIC probe: TI 1250A rev 02 PCI-to-CardBus at slot 00:14, mem 0x68000000 host opts [0]: [serial pci & irq] [pci irq 9] [lat 168/176] [bus 32/34] host opts [1]: [serial pci & irq] [pci irq 9] [lat 168/176] [bus 35/37] ISA irqs (scanned) = 3,10,11,15 PCI status changes cs: IO port probe 0x0c00-0x0cff: excluding 0xcf8-0xcff cs: IO port probe 0x0800-0x08ff: excluding 0x800-0x807 cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x300-0x307 0x370-0x37f 0 x388-0x38f 0x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: clean. cs: memory probe 0xa0000000-0xa0ffffff: clean. eth0: NE2000 (DL10022 rev 30): io 0x320, irq 3, hw_addr 00:50:BA:79:AF:D7 VFS: Disk change detected on device ide0(3,64) ISO 9660 Extensions: Microsoft Joliet Level 1 ISO 9660 Extensions: RRIP_1991A ISO 9660 Extensions: Microsoft Joliet Level 1 ISO 9660 Extensions: RRIP_1991A (null):~# lsmod Module Size Used by nls_cp437 3872 0 (autoclean) pcnet_cs 10340 0 (unused) 8390 5916 0 [pcnet_cs] ds 6028 2 [pcnet_cs] i82365 21072 2 pcmcia_core 42384 0 [pcnet_cs ds i82365] uart401 5852 0 sound 56360 0 [uart401] soundlow 364 0 [sound] soundcore 2436 3 [sound] unix 11332 9 (autoclean) (null):~# (null):~# cat /proc/interrupts CPU0 0: 83954 XT-PIC timer 1: 0 XT-PIC keyboard 2: 0 XT-PIC cascade 4: 5156 XT-PIC serial 8: 1 XT-PIC rtc 9: 6 XT-PIC i82365 13: 1 XT-PIC fpu 14: 141805 XT-PIC ide0 NMI: 0 (null):~# (null):~# uname -a Linux (null) 2.2.19 #1 Sat Jun 9 13:04:06 EST 2001 i686 unknown (null):~# (null):~# dmesg | head Linux version 2.2.19 (herbert@gondolin) (gcc version 2.7.2.3) #1 Sat Jun 9 13:04 :06 EST 2001 BIOS-provided physical RAM map: BIOS-e820: 0009f000 @ 00000000 (usable) BIOS-e820: 0ff00000 @ 00100000 (usable) # ::: 1:2345:respawn:/sbin/getty 38400 tty1 #2:23:respawn:/sbin/getty 38400 tty2 #3:23:respawn:/sbin/getty 38400 tty3 #4:23:respawn:/sbin/getty 38400 tty4 #5:23:respawn:/sbin/getty 38400 tty5 #6:23:respawn:/sbin/getty 38400 tty6 # Example how to put a getty on a serial line (for a terminal) # T0:23:respawn:/sbin/getty -L ttyS0 9600 vt102 #T1:23:respawn:/sbin/getty -L ttyS1 9600 vt100