[Please CC me, I am not subscribed.] Hi list!
I just tried to install etch to RAID1 using a debian-testing-amd64-netinst.iso from a few days ago. For various reasons I would have liked to use a partitionable md array (/dev/md_d*). Creating the array (on the commandline) worked great. However the build speed was very low, only about 1MB/s. I get 40-70MB/s for raid5 rebuilds on this hardware, albeit booted from a completed testing install on a seperate disk ... very strange. This was as far as I got, because partman refuses to have anything to do with the array. Upon selection of "partition harddisk" I get an error about partman not being able to open /dev/md/_d0. (Figures.) I don't know how it get to this broken path -- my attempts to coax it into cooperation using symlinks failed. I am then left with no options but back or cancel. A lot of the following steps require this one to complete, so that was it. I don't know enough to emulate successful completion of a config step. Regards, Christian -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
