Have gone back to Woody again on that laptop - so no record of last install.
Will try again at the weekend.
You asked about 3.1.
Installed this (3.1r5) on a 'similar' machine (Toshiba Tecra 530CDT - 32 MB
of ram - 1.4 GB hard drive) with the same model of ethernet pcmcia card, and
it worked fine after the re-boot.
Regards
Mal
On 16/05/07, Christian Perrier <[EMAIL PROTECTED]> wrote:
Quoting Mal Phillips ([EMAIL PROTECTED]):
> OK - thanks for the advice.
>
> Just to add, that I have just carried out an installation using the
'full'
> disk set (although it actually only required disk one - then downloaded
the
> rest). Same problem. Card recognised on install - then ignored on
re-boot.
What are the installed packages ('dpkg --get-selections', in the hope
that you installed only a base system so that this remains readable)?
Is the pcmciautils package installed?
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.6 (GNU/Linux)
iD8DBQFGSozq1OXtrMAUPS0RAu9yAKCEwHGZ4uy9vcAPOquzkNgh2/+YaACgnMnP
DkmhLV0tmRfN2EIv4pWoipM=
=Au4Z
-----END PGP SIGNATURE-----
